Every time I try to print a miniature figure it ends up either snapping half way or getting half way then become a stringy mess does anyone have any ideas on what I’m doing wrong if I print one of the pre installed projects it comes out flawless
@apple_user_1742662174 try re slicing it and see if it needs supports if it falls of or prints a stringy mess put supports
Also try increasing the infill %. I have had decent success with minis on my Tina2s.
@apple_user_1742662174 you may be using the wrong filament it's best to use a high printing pla
@Monkey-4 yes try to stick with pla it will make your machine run smooth
Every time I try to print a miniature figure it ends up either snapping half way or getting half way then become a stringy mess does anyone have any ideas on what I’m doing wrong if I print one of the pre installed projects it comes out flawless
