Nozzle Temp Error S1
-
I have an Entina 2S which has wished great for a couple of months. This morning, I have been receiving a "Nozzle temp Error S1". It will heat up enough to change filaments, and will start a print, but then that error occurs and the print fails. What can I do? Basic instructions of you have them, please. I'm a novice.
-
@Mine Please try carefully reconnecting the hotend cable to ensure it is properly seated. In some cases, a loose connection can lead to malfunction.
If the issue persists after re-plugging, it is likely that the hotend has sustained damage and will require replacement. You can obtain a compatible hotend assembly using the link below:
Replacement Hotend Assembly – Tina2 V9/V10 with 10P Cable -
Thank you! That did the trick! I already had a replacement hotend just in case, I just didn't know how to know when to change it out.
