Posts made by LR 0

@陆
That’s amazing. Thank you so much ️

Hi all

I recently got the Tina2S and managed to print a few models. I’m completely new to 3D printing and still have a lot to learn .

Everything has been printing fine so far but I encountered a problem when I tried to cut a clay cutter with a sharp edge. Basically after doing the slicing the object the thin edge disappears and the printer doesn’t print it.

I think the way the cutter is designed is that the outer wall stops half way and only the inside wall continues to the top with only 0.4 thickness. So basically I need only one wall printed for the last 5mm of the cutter.

Is there specific settings in Wiibuilder that will allow me to print this? I understand Cura had the option to print thin walls but I was wondering if this can be achieved in Wiibuilder too.

Would appreciate any suggestions. Thank you.