Does anyone know how to adjust your print setting so prints that have movable pieces have thicker connective ligiments. So many prints I have tried that move break easily from flimsy connective parts? Like the skeleton print and the scorpion print.
Thanks in advance for any help on this problem or advice...

@MadMan702 mine did same thing when i pulled the plug accidentally in middle of a print I know u can stilll save it if you have a slicer program available to you downloaded and ready to go then u can measure in cm and print a portion to glue together your 2 prints through the slicer program app. Plenty of how to videos on that if you need help just google or you tube search it.

@Lukey Since power loss option is rarely known about to a new printer I'll assume you didn't have that feature on your firsts prints. Your likely to have your machine stuck with it down on top of the print, same happened to me . So hard to find info on that, I know.

Here is what u do. Just push reset button down for a few seconds with a pen tip or paper clip it's on bottom left side of led screen. That resets machine. Or go to option restore to factory settings then the printer will release your design and move out the way so u can slide the plate off. We put our fresh prints in fridge for a min before we use a Adults only (sharp blade)or if a kid have a grown up help you to pry under print without scratching plate carefully. Hope this helped Enjoy your next print.