I heard a loud noise come from the machine. I ran out and saw that the entire print shifted about a half an inch. I’m assuming the noise was the printhead shifting. What would cause this to happen? The printer is in a different room on an even secured flat surface. The wires inside the machine were not messing up the printhead either.
What am I doing wrong?!
@Jake-Forsyth I’d like to propose some adjustments that should help resolve the problem.
In Wiibuilder, you can:
2. Modify the H Top Height: Change the H top height to 0.4mm.
@Jake-Forsyth said in Why are prints shifting mid print?!?:
I heard a loud noise come from the machine. I ran out and saw that the entire print shifted about a half an inch. I’m assuming the noise was the printhead shifting. What would cause this to happen? The printer is in a different room on an even secured flat surface. The wires inside the machine were not messing up the printhead either.
What am I doing wrong?!
@Neil Usually caused by printing at too fast a speed.
@Jake-Forsyth I’d like to propose some adjustments that should help resolve the problem.
In Wiibuilder, you can:
2. Modify the H Top Height: Change the H top height to 0.4mm.
