shifted layering
-
-
@Haomou-Ji mine has done this twice aswell so I'm looking for the same answer
-
@Jacob-c i manually pulled/pushed the plate the other day. the very recent print was ok.
-
if you are using other slicer like cura or other then most probably the solution is to lower the speed and/or use jump or left nozzle while moving.
and if you are using poloprint cloud dont set the speed to 150 use normal for best result and speed.
-
@Haomou-Ji I’d like to propose some adjustments that should help resolve the problem.
In Wiibuilder, you can:
- Adjust the Travel Speed: Set the travel speed to 40.
- Modify the H Top Height: Change the H top height to 0.4mm.
These changes are designed to improve alignment and enhance the overall performance of your setup. If you need further assistance in making these adjustments or have additional questions, please don’t hesitate to let me know.
- Adjust the Travel Speed: Set the travel speed to 40.