Help asap

[apple_user_1742512743]

Anytime I try to print something the filament doesn’t come out. I push the filament and then it begins to come out and print as it should. However, a couple seconds after i remove my hand, the filament stops coming out the nozzle. what should i do?

[apple_user_1742513984]

@apple_user_1742512743 do you have enough in the feeder or is there not enough for the teeth to grip on

[apple_user_1742513984]

@apple_user_1742513984 if that dose not work try unataching the tube and check if you filament is damp or dusty and then after checking your roll put the tube back in make sure it’s in there sturdy.

[陆]

@apple_user_1742512743

Please kindly inspect whether the filament is extruding properly by referring to the video provided below:
Video Link

Should the issue persist, it is plausible that the screws may be excessively tightened. I recommend slightly loosening them to see if this resolves the problem.

[apple_user_1742513984]

@陆 or Mabe just try cleaning the nozel

[apple_user_1742513984]

@apple_user_1742513984 has it worked ?

[DXRKRCR]

I had a similar issue with my printer. Middle of the night, it started jamming. I had to take off my hotend and remove the nozzle. Filament got dried up inside it. Try maxing out the temp and feeding filament through the tube into the hotend to unstick any filament inside. DO NOT LET THE FILAMENT FFROM THE TUBE MELT IN THE HOTEND. You will have a major issue if it melts.