Printing thin walls in Wiibuilder

[LR 0]

Hi all

I recently got the Tina2S and managed to print a few models. I’m completely new to 3D printing and still have a lot to learn .

Everything has been printing fine so far but I encountered a problem when I tried to cut a clay cutter with a sharp edge. Basically after doing the slicing the object the thin edge disappears and the printer doesn’t print it.

I think the way the cutter is designed is that the outer wall stops half way and only the inside wall continues to the top with only 0.4 thickness. So basically I need only one wall printed for the last 5mm of the cutter.

Is there specific settings in Wiibuilder that will allow me to print this? I understand Cura had the option to print thin walls but I was wondering if this can be achieved in Wiibuilder too.

Would appreciate any suggestions. Thank you.

[陆]

@LR-0 said in Printing thin walls in Wiibuilder:

Hi all
I recently got the Tina2S and managed to print a few models. I’m completely new to 3D printing and still have a lot to learn .
Everything has been printing fine so far but I encountered a problem when I tried to cut a clay cutter with a sharp edge. Basically after doing the slicing the object the thin edge disappears and the printer doesn’t print it.
I think the way the cutter is designed is that the outer wall stops half way and only the inside wall continues to the top with only 0.4 thickness. So basically I need only one wall printed for the last 5mm of the cutter.
Is there specific settings in Wiibuilder that will allow me to print this? I understand Cura had the option to print thin walls but I was wondering if this can be achieved in Wiibuilder too.
Would appreciate any suggestions. Thank you.

After further investigation, we have identified that the problem is related to the wall thickness. To rectify this issue, we are currently testing a new function in our wiibuilder software, specifically designed to address the wall thickness problem. We are pleased to inform you that the testing process is progressing well, and we anticipate completing it by tomorrow and we can send it to you then.

[陆]

@陆
https://drive.google.com/file/d/1BvmSgBRk916ywXKKFXLIrSTV7zD-irV2/view?usp=sharing

[LR 0]

@陆
That’s amazing. Thank you so much ️

[Yvonne]

@陆 said in Printing thin walls in Wiibuilder:

@陆
https://drive.google.com/file/d/1BvmSgBRk916ywXKKFXLIrSTV7zD-irV2/view?usp=sharing