7 Jan 2025, 12:09
I did convert tls file to encode and transfer file through sd card for printing. A 63g controller stand took me over 12 hours. Not sure if there is any miss config or it is a normal perform?
my print takes too long?
-
I did convert tls file to encode and transfer file through sd card for printing. A 63g controller stand took me over 12 hours. Not sure if there is any miss config or it is a normal perform?
-
@Haomou-Ji If you are uncertain about the changes made, I recommend restoring the default settings to see if any unintended adjustments to the parameters might have caused the longer printing time. This will help determine if a setting was inadvertently altered.
-
@陆 thanks Eric, i should give it a go and see
-
@陆 actually,.it works. Some settings must got reset and brought down the printing time significantly. Thank you!